MAGNETIC STAND for Dial & Digital Indicator

==============================================================

  

1. Universal Mechanical Arm Magnetic Stand
Widely used in the manufacturing industry.
Used for clamping dial indicators, micron dial indicators and dial test indicators , etc. It can scribe on workpiece if it’s attached with a scriber.
Can be adjusted to any angle needed. It’s an ideal checking device.
This strong stand is with ON/OFF switch.

	Order No.	Magnetic force
	723-102	60kg	588N

 

================================================================

 

 2. Magnetic Stand with Fine Adjustment

Widely used in the manufacturing industry.
Used for clamping dial indicators, micron dial indicators and dial test indicators , etc. It can scribe on workpiece if it’s attached with a scriber.
Can be adjusted to any angle needed. It’s an ideal checking device.
This strong stand is with ON/OFF switch.

Order No.	Magnetic force
723-101	60kg	588N

 

-------------------------------------------------------------------------------------------------------

3. Flexible Stem Magnetic Stand Widely used in the manufacturing industry. Used for clamping dial indicators, micron dial indicators and dial test indicators , etc. It can scribe on workpiece if it’s attached with a scriber. Can be adjusted to any angle needed. It’s an ideal checking device. This strong stand is with ON/OFF switch. Order No. Magnetic force 723-104 60kg 588N =============================================== notes: 1. Universal Mechanical Arm Magnetic Stand- Actual Photos

Circuitworks Overcoat Pen CW3300G

 CircuitWorks® Overcoat Pen

The pen dispenser for precise application of a tough protective acrylic conformal coating

·  Simple to use, single component system

·  Hard, durable coating

·  High dielectric strength helps prevent electrical discharge

·  Dries quickly at room temperature

·  Protects against moisture and abrasion damage

·  Meets requirements of MIL-I-46058C and IPC-CC-830A

·  Choice of clear, blue or green coating

Applications:

·  Protects conductive pen traces

·  Repairs permanent solder mask with conformal coating

·  Prevents shorting and arcing

CW3300C Clear 4.9 g (0.16 oz)
CW3300G Green 4.9 g (0.16 oz)
CW3300B Blue 4.9 g (0.16 oz)
CW3300BLACK Black 4.9 g (0.16 oz)

Origin = USA

 ============

Notes:
It is used to provide insulation of printed circuit boards, typically after rework and repair, where it can take the place of permanent solder mask, solder resist or conformal coating. It was designed to insulate printed circuit board tracks, traces and components against high voltage arcing. It also provides protection from moisture and fungus. The pen configuration is useful for rework when precision application is necessary.

Applications

• Touch-up and rework & repair of printed circuit boards
• Replacement of permanent solder resist or mask
• Repair of membrane switch keypads

Directions
Use the Overcoat Pen for the protection of repaired tracks. Depress the pen on hard surface continuously until material is released and starts to flow. Generously apply material over the repair surface. Make sure to overlap onto the original coating to ensure full coverage of application. Allow 24 hours for complete cure at room temperature. For accelerated curing, place in oven for 20 minutes at 50°C, and then again for 30 minutes at 82°C.

Ref: http://www.chemtronics.com/msdstds/results.asp , http://www.intertronics.co.uk/products/tec2508.htm

 notes:

1. Equivalent product=  TechsprayTEC2509-GN          Overcoat Pen Green - 5ml