Search Product Code or MPN or SKU here!

Lagunastar Industries Company

软焊 软焊 / はんだ付け はんだ付け
3rd Floor Unit C-22 Banawe de Sta. Rosa Bldg, Balibago, Santa Rosa City, Laguna Philippines 4026
--
Mob. 0933-5996622 SUN ,Mob. 0931-1147369 SUN, Mob. 0976-1479802 Globe , Tel. 049-2542179 --
lagunastar1@yahoo.com, lagunastar1@gmail.com, lagunastar3@yahoo.com ,
--
Skype :lagunastar.industries1 , lagunastar.industries2 , FB page= Soldering Anti-Static

Labels

Sep 18, 2012

Circuitworks Overcoat Pen CW3300G






 CircuitWorks® Overcoat Pen
The pen dispenser for precise application of a tough protective acrylic conformal coating
·  Simple to use, single component system
·  Hard, durable coating
·  High dielectric strength helps prevent electrical discharge
·  Dries quickly at room temperature
·  Protects against moisture and abrasion damage
·  Meets requirements of MIL-I-46058C and IPC-CC-830A
·  Choice of clear, blue or green coating

Applications:
·  Protects conductive pen traces
·  Repairs permanent solder mask with conformal coating
·  Prevents shorting and arcing

CW3300C Clear 4.9 g (0.16 oz)
CW3300G Green 4.9 g (0.16 oz)
CW3300B Blue 4.9 g (0.16 oz)
CW3300BLACK Black 4.9 g (0.16 oz)
Origin = USA
 ============
Notes:
It is used to provide insulation of printed circuit boards, typically after rework and repair, where it can take the place of permanent solder mask, solder resist or conformal coating. It was designed to insulate printed circuit board tracks, traces and components against high voltage arcing. It also provides protection from moisture and fungus. The pen configuration is useful for rework when precision application is necessary.
Overcoat Pen applicationApplications
  • Touch-up and rework & repair of printed circuit boards
  • Replacement of permanent solder resist or mask
  • Repair of membrane switch keypads


Directions
Use the Overcoat Pen for the protection of repaired tracks. Depress the pen on hard surface continuously until material is released and starts to flow. Generously apply material over the repair surface. Make sure to overlap onto the original coating to ensure full coverage of application. Allow 24 hours for complete cure at room temperature. For accelerated curing, place in oven for 20 minutes at 50°C, and then again for 30 minutes at 82°C.

 notes:

1. Equivalent product=  TechsprayTEC2509-GN        
 Overcoat Pen Green - 5ml
 
 
 

 
 
 

 

Pls see Older Post or Labels

Pls see Older Post or Labels